CR-10 Essential Mod Set

These are the 3 Essential Mods you need for your CR-10 (300x300x400 CR-10 the wheels do not fit the s5. Not sure about the s4 but i dont think so. They might fit the new mini i will test this week)

Ultimate Leveling Knobs. just trust me. you will never go back. I wish all printers could take advantage of massive knobs like this.

Y Strain Relief - Relieves stress on your heat bed connection

Fan Duct Remix. a small change to put the part cooling air where it needs to go.

you pretty much don't NEED any other mods for this printer. its that good. there are other mods. search around. this is just the essential mods you need.

it prints as a "full plate" in sequential print mode (one part at a time) better quality that way but you need a nice level bed to make sure all the parts stick.

the STL is all the parts. use separate connection parts if you want to jocky them around or slice on your own.

the gcode is pre programmed for the CR-10 in sequential print mode. Load. Prin