CR-10 Hotbed Camera Mount - Modular Mounting System Compatible

This mount is a remix of [steezebe](https://www.thingiverse.com/steezebe)'s [design](https://www.thingiverse.com/thing:3046587) for the CR-10, which was inspired by [Vincentvoile](https://www.thingiverse.com/Vincentvoile)'s [design](https://www.thingiverse.com/thing:2916261) for the CR10S. It's a single sturdy piece that, when the camera is removed, is completely out of the way. It is compatible with [yyh1002](https://www.thingiverse.com/yyh1002)'s [Modular Mounting System](https://www.thingiverse.com/thing:2194278).

This remix includes:
- Deeper, wider slots for ease of installation.
- The upper tines on the left and right sides have been made thinner to allow the bed to be lowered further than the original design allows.
- The go-pro mount has been made stronger and can now be printed without supports.

To install, first release the tension on the front levelling bed knobs, and slide the right side in. Then, swing the left side in from the back, and tighten the bed back do