Thingiverse
CR-10 Power supply support
von Ianardo
5
Downloads
4
Likes
0
Makes
A support for the CR-10 power supply which stops it tipping when the filament it tightly wound.
I use double sided tape along the bottom of the support to help keep it firmly on the table, but this is optional.
I use double sided tape along the bottom of the support to help keep it firmly on the table, but this is optional.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!