Thingiverse
CR 10 side light switch holder
von Bee69
12
Downloads
6
Likes
0
Makes
Hi I made this switch holder to take a 21mm X31mm 12v automotive switch. There are two differant holders one is straight on, and the other(this one) is a side on light switch holder. I made this one to fit on the rail at the front left hand side. (as you look at it from the front) but it is technicaly the right side.
Hope it helps you out.
Hope it helps you out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
