Thingiverse
CR-10 Spool Holder
von branman6875
15
Downloads
5
Likes
0
Makes
Okay, fixed version is up!
I wanted a better spool holder, but didn't want to completely do away with the stock bracket. This is essentially a sleeve bearing designed to fit over the stock 32mm pipe. It prints in four pieces (you need two dividers) and uses 24x 4.5mm steel BB's. It can hold any filament spool with a center hole of 54mm or larger.
Print as upright cylinders, no supports. I recommend a brim as it's not a ton of surface area to stick down.
A bit of 3-in-1 oil or similar lubricant on the BB's will make it roll a lot smoother.
I wanted a better spool holder, but didn't want to completely do away with the stock bracket. This is essentially a sleeve bearing designed to fit over the stock 32mm pipe. It prints in four pieces (you need two dividers) and uses 24x 4.5mm steel BB's. It can hold any filament spool with a center hole of 54mm or larger.
Print as upright cylinders, no supports. I recommend a brim as it's not a ton of surface area to stick down.
A bit of 3-in-1 oil or similar lubricant on the BB's will make it roll a lot smoother.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
