Thingiverse
CR-10 stabiliser and support
door MontagueFlange
66
Downloads
42
Likes
0
Makes
It stops the 'drop' on the X carriage and means you don't have to get motor lead screw wire etc. It's just another option
READ INSTRUCTIONS FULLY FIRST, READ THEM AGAIN.
Print the parts.
List of parts needed to fit it
8 x 5mm T Nuts
8 x 5mmx10 dome socket head screws
2 x 5mmx35mm Socket head screws
1 x 5mmx40mm Socket head screw
6 mm washers
3 5mm nuts
3.2mm Drill To clear the holes out on the bearing bracket
2 LM8 linear bearings.
8mm ROD 570mm long (Pick your own type of rod.)
Tools files etc.
DO NOT TIGHTEN ANYTHING UNTIL ALL PARTS ARE FITTED.
REMOVE THE CABLES FROM THE Z AND X MOTORS
File/sand the bearing holder so the LM8 bearings slid in tight. Put the circlip in, or use your own.
Clear drill the 3 holes in the plate.
Undo the 2 screws holding the plate on
On the right side undo the screw holding the top outside wheel on, Poke it out with the alan key, Use a 35mm m5 and replace the screw, put a spare washer in then the lock nut an
READ INSTRUCTIONS FULLY FIRST, READ THEM AGAIN.
Print the parts.
List of parts needed to fit it
8 x 5mm T Nuts
8 x 5mmx10 dome socket head screws
2 x 5mmx35mm Socket head screws
1 x 5mmx40mm Socket head screw
6 mm washers
3 5mm nuts
3.2mm Drill To clear the holes out on the bearing bracket
2 LM8 linear bearings.
8mm ROD 570mm long (Pick your own type of rod.)
Tools files etc.
DO NOT TIGHTEN ANYTHING UNTIL ALL PARTS ARE FITTED.
REMOVE THE CABLES FROM THE Z AND X MOTORS
File/sand the bearing holder so the LM8 bearings slid in tight. Put the circlip in, or use your own.
Clear drill the 3 holes in the plate.
Undo the 2 screws holding the plate on
On the right side undo the screw holding the top outside wheel on, Poke it out with the alan key, Use a 35mm m5 and replace the screw, put a spare washer in then the lock nut an
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
