CR-10 v2 stand alone

This is my mod to the CR-10 v2 to make it standalone, clean and quiet.

More info on assembly will come.

Materials:
- 24 - M3 x 5 screws
- 24 - M3 nuts
- 4 - M4 x 10 screws
- 4 - M5 x 60 screws and some washers
- 8 - PCB standoffs/spacers male to female, with a length of 10 mm + 6 mm
- Some 2,5 mm² wires (preferably black and red)
- 15 - forked cable shoe
- 2 - 10 pin flat ribbon cable 50 cm (For the display)
- 2 - 120 mm fans
- 1 - 80 mm fan
- 1 - Wood board, countertop or another material with the dimentions of at least 52x40 cm
- 1 - Micro-usb extention cable, preferably with panel mounting. Then you also need some M3 x 10/12 srews to mount this if it doesnt come with it.
- Superglue
- If you are printing with SD-card, i would really recomend picking up a Raspberry pi to print with octoprint instead. Since the SD card is not easely accesible.


If you want to remove the power supply cover i recomend printing a vented cover for it to avoid accidentaly touching a