Thingiverse
CR-10 V3 Standoff
by TheDude93
38
Downloads
23
Likes
1
Makes
I was always annoyed with the control box being off to the side of my new Creality CR-10 V3 printer, so I decided to do something about it. The control box now sits underneath the printer and really cleaned up my workspace a bunch by giving the wires a place to hide.
The standoffs have a 30mm (1.25 inches) platform with a lip on the top to prevent the feet from sliding off, and they lift the printer about 90mm (3.5 inch) up from it's normal position. It's surprisingly stable.
The inside is not solid, but does have a center post to give it vertical strength. It does not take up too much filament, but I'm sure someone out there could improve it. Feel free to remix it if you do!
The standoffs have a 30mm (1.25 inches) platform with a lip on the top to prevent the feet from sliding off, and they lift the printer about 90mm (3.5 inch) up from it's normal position. It's surprisingly stable.
The inside is not solid, but does have a center post to give it vertical strength. It does not take up too much filament, but I'm sure someone out there could improve it. Feel free to remix it if you do!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
