CR-10S Filament sensor bracket

Update V2 : As the base of the sensor bracket was not strong enough for me, I increased the thickness of it and reinforced the holes of the fastening screws

Owner of a Creality CR-10S, I was upset by the original sensor bracket wo was moving during retractation and which blocked sometimes the filament.
And also as my CR-10S is in an enclosure I noticed that after printing pieces in ABS, the original sensor bracket started to bend and move a lot...

So I draw this Filament sensor bracket.

You'll need :
3 CHC M3x12 screws for the cover.
2 little lenghts of Bowden tube

I printed it in ABS