CR-10s Pro Bed Table Legs

This design was made to retrofit onto the stock hot bed of a Creality Cr-10S Pro. I made (as pictured) a lot of newbie 3D-printing mistakes that ruined this bed, so I decided to by a new Wham Bam Flexible Build System bed to replace it. After the new installation I realized that I had this awesome piece of aluminum that was just sitting there, so I decided to build these fitting to make it into a table. The design is simple and I'm sure it would not be difficult to redesign it to make it a taller table, but i just needed something short. Printing these one at a time reduces the warping, but printing 4 at once gets it done quicker and it'll still sit level on a flat surface.

**The legs fit snugly right onto the bed, no hardware required!**