Thingiverse
CR-10S Pro Work Light
von Williamsonis
9
Downloads
1
Likes
0
Makes
This is a lamp I made for my CR-10S Pro, it slides onto the base of the machine and doesn't get in the way.
I used LED strips cut to size so there are 6 strips side by side.
The power source is from a 12Volt adaptor but could be hard wired into the machine with the use of resistors.
Thank you to stylesuxx for the thumb screw design that I have included.
I used LED strips cut to size so there are 6 strips side by side.
The power source is from a 12Volt adaptor but could be hard wired into the machine with the use of resistors.
Thank you to stylesuxx for the thumb screw design that I have included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
