Thingiverse
CR-30 Direct Drive
113
Downloads
65
Likes
0
Makes
This started with a very nice direct drive mount from codfish124, https://www.thingiverse.com/thing:4832139. I remixed it, bringing the extruder gears closer inline with the hot end. I lowered it by about 6mm. Then I added a cable strain relief and mounting for a Bowden tube or grommet for a Palette. It requires two 3X12mm bolts and two 3X6mm bolts and a few cable ties.
At the other end of the Bowden tube is a mount for the cable and filament runout sensor. It pivots. It requires three 5X8mm bolts and t-nuts and a few cable ties. Three mounts have been uploaded. I played with a few designs, so one may choose for themselves.
The nuts I made because the Palette 2 comes with only two grommets and they are made specifically for Mosaic. Eventually, I want my Palette 2 to be able to move between various printers, so I designed this nuts idea. The Bowden tube connector will take some work to seat in the mount properly.
The Nuts Mount uses two 4X8mm bolts and t-nuts.
The extruder
At the other end of the Bowden tube is a mount for the cable and filament runout sensor. It pivots. It requires three 5X8mm bolts and t-nuts and a few cable ties. Three mounts have been uploaded. I played with a few designs, so one may choose for themselves.
The nuts I made because the Palette 2 comes with only two grommets and they are made specifically for Mosaic. Eventually, I want my Palette 2 to be able to move between various printers, so I designed this nuts idea. The Bowden tube connector will take some work to seat in the mount properly.
The Nuts Mount uses two 4X8mm bolts and t-nuts.
The extruder
8FootedAlgaeEater veröffentlicht auch auf
24 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
