Cr10 Direct Drive upgrade

This is a collection of parts that i created to convert my cr10 into a direct drive extuder printer.

Be warned this makes your printer loud due to the fans.

OFFSET SPACER
The Offset spacer part not only creates the clearance for the extruder, but also supports the extruder instead of just hanging off 2 scews.
(Print in PETG, 100% infill)

UPPER DUCT 5015 Stock/PRO
I have 2 different fan mounts (using 5015 fans) one for the Cr10, and one for the CR10 PRO hotend. I replaced the stock CR10 hot end with the CR10 PRO version and it has helped so much for heat creep.

These fan mounts are nice because it is 1 print for both the part cooling fan, and the hotend cooling fan. It is relatively low profile, and snaps into place. I highly recommend using tape or glue to fully secure the fans to the mount.
(Print in ABS/ASA for best temperature resistance)
(I used tree supports touching buildplate only)

SPACER PLATE
There is a "Spacer Plate" that needs to be printed for each of