Thingiverse
CR10 / Ender 3 Spool Holder
door aquinn97
1
Downloads
1
Likes
0
Makes
This part is a one part low profile filament spool holder. I've swapped out my standard Ender 3 spool bracket with this. After viewing so many over engineered spool holders I came up with this one part design. Can be mounted horizontal or vertical.
It will work with any 3D printer that has a frame than can take M3 or M4 bolts with, typically 20x40 6mm slot or 20x20mm 6mm slot. Designed for 8mm long bolts with T nuts.
This can reduce the overall height of the printer so it can sit on a bookshelf, or anywhere where reduced headroom is important.
Takes spools up to 85mm width, which is usually 1kg spools.
Print with 20% infill minimum for strength, and min 1mm wall thickness ideally, though thinner walls will work just fine with lower mass spools.
It will work with any 3D printer that has a frame than can take M3 or M4 bolts with, typically 20x40 6mm slot or 20x20mm 6mm slot. Designed for 8mm long bolts with T nuts.
This can reduce the overall height of the printer so it can sit on a bookshelf, or anywhere where reduced headroom is important.
Takes spools up to 85mm width, which is usually 1kg spools.
Print with 20% infill minimum for strength, and min 1mm wall thickness ideally, though thinner walls will work just fine with lower mass spools.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
