CR10 Portable

I've created this case to make the CR10 portable with the a mounting plate for RAMPS, the original CR10 MOSFET, the RaspberryPi and the CR10 power supply and a mounting plate for the Melzi (including the CR10S board), original CR10 MOSFET, the RaspberryPi and the CR10 power supply.

Screws needed:
15x (or 17x) M4x10 (6 for the electric case, 6 for the power supply case, 1 for the power switch feet & 2 or 4 for the display depending on wich you are printing)
16x M4x40 (for the Squashball feet, you can use tho old T-Nuts - hammer nuts)
13x M4 T-Nuts (Hammer Nuts)
4x M3x5 - maybe M3x10 work also (for the power supply)
1x M3x10 (for the screw to connect the two cases together at the front)
4x M4x40 (for the 140mm fan)
2x Metal screws for the power switch
Metal screws for the PI, MOSFET and the Board you are using
(4x M3x10 for the display depending on wich you are printing)
(if you use the cable guides you also need 1x M4x10 and 1x M4 T-Nut - hammer nut for one guide)

With t