MakerWorld
3D Printer Accessories
Go to Model
CR10 SMART LED BARS
17
Downloads
12
Likes
0
Makes
To plug in the strips, use the connections on the daughter board shown in the image. IMPORTANT: It must be a 24V LED STRIP or you will fry the LEDs or worse. You will also need two JST xh2.54 connectors.If you want to avoid using the printer's power, you can use any LED strips.The front bar has a small hole on the left to allow the wire to connect to the daughter board; the rear bar has a gap to aid in this as well.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
