CR10 Tool Holder

I wanted a tool holder that could also provide support from bottom to help prevent tipping. I also wanted to to have option to capture [Raspberry Pi Sleeve Case by Walter](https://www.thingiverse.com/thing:604915).

If you do not need Raspberry Pi support, then print out two of the standard supports. The tool holder is attached to the supports using the following hardware from Lowes:

[QTY 2 M5-.80 x 20 Pan Phillips Machine Screw](https://www.lowes.com/pd/Hillman-5mm-to-0-8-Phillips-Drive-Zinc-Plated-Machine-Screws-8-Count/999994844)
[QTY 2 5mm Lock Washers](https://www.lowes.com/pd/Hillman-20-Count-5mm-Metric-Internal-Tooth-Lock-Washers/999995412)
[QTY 2 M5-.8 Hex Nut](https://www.lowes.com/pd/Hillman-12-Count-5mm-Zinc-Plated-Metric-Hex-Nuts/999995428)

All parts can be built based on the orientation shown in picture above. I only used supports on the pi holder support leg.


Update 8/6/2008: I noticed the pi support leg warping in the heat of my garage so I designed