Thingiverse
CR10 v2 Floating Tool Tray
door qwiktune
17
Downloads
8
Likes
0
Makes
I liked JPGrox's Ender 3 tool caddy but the rail on my CR10 v2 doesn't have the center section his tray clips on to so I modified it to allow for T nuts. This gives pretty much the exact same result with a different method of attachment.
I modified my first version it to be flush with the rail sizing putting the T nuts in the center for aesthetics, but also made it slightly thinner as well.
*VERSION 2*
This version I extended 2 of the micro sd slots to work with full size SD cards and converted the small wrench slots different and cut open all the way through the nozzle holes as I could knock them off too easy with the original design....assuming becuz when I made it thinner the original slots werent as deep anymore......I also trimmed 1mm off each side just to make it a little less material.
I modified my first version it to be flush with the rail sizing putting the T nuts in the center for aesthetics, but also made it slightly thinner as well.
*VERSION 2*
This version I extended 2 of the micro sd slots to work with full size SD cards and converted the small wrench slots different and cut open all the way through the nozzle holes as I could knock them off too easy with the original design....assuming becuz when I made it thinner the original slots werent as deep anymore......I also trimmed 1mm off each side just to make it a little less material.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
