CR10 V3 Filament Sensor Guide Bracket

This is a modification of the https://www.thingiverse.com/thing:4678852

I removed the bearing post and changed it to a M8 hole. Use M8-1.25 x 1.25 or longer screw/bolt 4 to 6 washers to center the Type 608ZZ ball bearing.

I also added filets to all the corners to decrease stress points on the part

You need one bracket and one bearing runner printed.

Additional you will need the following:

1x M8-1.25 x 1.25in or longer screw/bolt
1x M8-1.25 Hex Nut
4 to 8 M8 washers