CR10 V3 mount remix

This is a remix of the E3D Fan mount upgrade for CR10 V3 Printer bymichaelfordltd2.
I remixed this mount to use heatset inserts to make dealing with the mount easier.
I also adjusted the fan duct to allow for more cooling around the part rather then all from one direction. Currently this remix uses both the original fans and all the original hotend components. I'm still playing with the design (currently on V5) and may make a few more tweeks going forward but so far this version is working well.

I printed my mount out of PETG though I may change that to ABS, ASA or some other higher temp material in the future right now it's working fine when printing PLA+ and PETG.

Note: slide your V6 in do not press the mount on to the V6 from the side as it may crack your mount if it's printed in PETG. Also it should be a snug fit but don't force it if the mount won't slide over the heatsink then use a lighter or other small directional heatsource to heat the area of the mount that clamps