Thingiverse
Cr10 Z stop extensions
par VentusV
1
Téléchargements
1
Likes
0
Makes
Two simple extensions for the Z stop.
They add 3mm and 5 mm height to your Z stop in case you get a thicker bed or glass/mirror on top of it.
Just push them onto the metal on the x gantry (the vertical arm) right above the z stop switch.
You can make them in PLA as there is no heat there so they wont warp, but of course PETG or other fancier plastic is good too.
Printed, tested, they fit just right. No glue needed.
If you need you can adjust their dimensions in the slicer of your choice.
They add 3mm and 5 mm height to your Z stop in case you get a thicker bed or glass/mirror on top of it.
Just push them onto the metal on the x gantry (the vertical arm) right above the z stop switch.
You can make them in PLA as there is no heat there so they wont warp, but of course PETG or other fancier plastic is good too.
Printed, tested, they fit just right. No glue needed.
If you need you can adjust their dimensions in the slicer of your choice.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
