CR10S Control Box Inverted Lack Bracket

This is for mounting the cr10s control box on an inverted lack table setup. I use lacks for the organization so if you use it as an enclosure you will have to modify it or use something else. I did not want to extend any wires so this was the best choice for me. There are countersunk holes for screws for the top and bottom part of the clamp section. I used just one screw on top and it's very strong. I also put some 3m double sided tape on the top section to keep the control box from sliding and possibly getting under the x gantry.

I used 3m double sided tape to secure the inverted table to the one underneath.

You could reduce print time by scaling it down on the z height. you will just need to drill the hole for the screw.