cr10s direct drive e3dv6

Cr10s- Cr10 Direct drive mount whit dual fan or single fan of ur choosing and pancake motor mount, or just use stock creality extruder motor but it will stick out a bit 15mm aprox.

Important thing is to use good RPM 40mm FAN for Sufficient Cooling, if not - lower melting materials might clog when retracted by the machine !!!! A good rpm fan means stock creality rpms or equivalent And more here : https://www.youtube.com/watch?v=XPrUUrKJAAE NO CLOGiNG iF U FOLOW THESE STEPS! TURN ON SUBTITLES IF U DONT UNDERSTAND ITALIAN.

Parts are light and sturdy! Im using it whit a pancacke stepper motor and its very light, whit a good filament filter whit a micro fiber cloth inside for no friction this setup will never almost never clog!! Just throw the stock hotend to the bin!!!

Printed whit ABS Glow, so when leds are turned off it glows for a while 10min+

Print details :



Material : ABS

Layer Height : 0.2 - 0.1 or less

Infill : 80%+

Support: Touching Buildpla