Thingiverse
CR10S Pro Bondtech Mount Direct Drive
door bangity
150
Downloads
100
Likes
2
Makes
Print with support enabled, This is a mount for NEMA 17 pancake 22mm thickness and Bondtech/clone extruder. It can print speed 100mm/s+. I used a 0.9 degrees for more resolution.
It will slide into the Gantry of the CR-10S Pro and secured by 2 M3 screws.It will work with MicroSwiss or any hotend. Just need a short 2-3cm PTFE tube to connect the 2.
There is a mount for a 3.5W Laser from Eleks that mount right on top of it. The laser unit itself is removable with just 1 M3 screw.
https://www.thingiverse.com/thing:3546208
It will slide into the Gantry of the CR-10S Pro and secured by 2 M3 screws.It will work with MicroSwiss or any hotend. Just need a short 2-3cm PTFE tube to connect the 2.
There is a mount for a 3.5W Laser from Eleks that mount right on top of it. The laser unit itself is removable with just 1 M3 screw.
https://www.thingiverse.com/thing:3546208
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
