Thingiverse
CR10S PRO filament guide
42
Downloads
32
Likes
0
Makes
This is a remix of two filament guides from thingiverse.
One clip fits the CR10 (from the original) and one is for the CR10S PRO.
I had to add 0.12mm horizontal expansion since it the original was a bit loose, but most likely depends on your printer setup...
One clip fits the CR10 (from the original) and one is for the CR10S PRO.
I had to add 0.12mm horizontal expansion since it the original was a bit loose, but most likely depends on your printer setup...
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!