Thingiverse
CR10S Pro Logitech C270 Camera Mount
door clif123
11
Downloads
2
Likes
0
Makes
I designed a Logitech C270 camera holder for my Creality 10S Pro. This printer has been upgraded to a v2 direct-drive but I designed the holder to sit next to the filament drive stepper for unmodified printers. I also designed this holder so the C270 camera is not modified other than re-focusing and can easily be removed and re-inserted.
Designed with FreeCAD 0.19
Sliced with Cura using a brim and supports when greater than 80 degrees.
Filament: eSun PETG @ 235C and bed temperature of 80C.
Use 3mm nuts/bolts to secure the mount to the 2 slots used for cable ties.
The mount has a ring on the back to secure the cables to using a cable tie.
Designed with FreeCAD 0.19
Sliced with Cura using a brim and supports when greater than 80 degrees.
Filament: eSun PETG @ 235C and bed temperature of 80C.
Use 3mm nuts/bolts to secure the mount to the 2 slots used for cable ties.
The mount has a ring on the back to secure the cables to using a cable tie.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
