Thingiverse
CR10SE Chain Mod
by cs301
7
Downloads
9
Likes
0
Makes
** I gave up the idea of this toolhead and designed an [adapter plate](https://www.thingiverse.com/thing:6688291) for the Hero Me Gen7. The original CR-10SE mounting bracket for the CR-Touch can still be used. The advantage is the free choice of fans and hotends.**
------
**!!! I had to file down the left rear spacer from the print bed a bit, just bevel a little from the side so that the screw head has space. Because it hit the screw head of the cable chain holder, As a result, the print bed was slightly tilted.**
The printer has now been completely rebuilt and is printing. I still have a small problem with the mainboard fan, it sits a bit too low and presses on the cables, so I'll have to think of a solution. The X axis cable chain is also not in line with the holder on the print head, which should be a little higher. But so far this has all just been a "design study".
-----
Sorry guys, I just prefer cable chains, but many of you don't. The original cable routing on this printer i
------
**!!! I had to file down the left rear spacer from the print bed a bit, just bevel a little from the side so that the screw head has space. Because it hit the screw head of the cable chain holder, As a result, the print bed was slightly tilted.**
The printer has now been completely rebuilt and is printing. I still have a small problem with the mainboard fan, it sits a bit too low and presses on the cables, so I'll have to think of a solution. The X axis cable chain is also not in line with the holder on the print head, which should be a little higher. But so far this has all just been a "design study".
-----
Sorry guys, I just prefer cable chains, but many of you don't. The original cable routing on this printer i
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
