Thingiverse
CR10v2 Antclabs BLtouch mount
von Waessman
21
Downloads
20
Likes
0
Makes
Antclabs BLtouch
CR10 v2 mount
Gives
Probe Z offset min -1.2 max -2.4
X 48
Y 0
Print orientation is with the dragon up, and the holes is made for this also (they have a higher roof that way).
Use bridge settings in cura, this works very well and no support is needed that way.
CR10 v2 mount
Gives
Probe Z offset min -1.2 max -2.4
X 48
Y 0
Print orientation is with the dragon up, and the holes is made for this also (they have a higher roof that way).
Use bridge settings in cura, this works very well and no support is needed that way.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
