Thingiverse
CR6 Raspberry Pi Case
door bollekeil
24
Downloads
9
Likes
0
Makes
It's a Remix of https://www.thingiverse.com/thing:3090773
I changed the design so that it fits perfectly on a Creality CR 6-SE. I enlarged the hole on the SD card so that you could easily take it out. As an alternative, I have attached a cable holder for a Pi-Cam so that it is not accidentally pulled from the bed.
Support is only needed on the bracket. The cable holder can also be printed without.
Even after several hours of printing, I never had any problems with PLA.
CR 6 PiCam Holder: https://www.thingiverse.com/thing:4842559
I changed the design so that it fits perfectly on a Creality CR 6-SE. I enlarged the hole on the SD card so that you could easily take it out. As an alternative, I have attached a cable holder for a Pi-Cam so that it is not accidentally pulled from the bed.
Support is only needed on the bracket. The cable holder can also be printed without.
Even after several hours of printing, I never had any problems with PLA.
CR 6 PiCam Holder: https://www.thingiverse.com/thing:4842559
bollekeil publiceert ook op
17 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
