Thingiverse
CR6-SE Flex bed corner guide
door Arvin_G
72
Downloads
34
Likes
0
Makes
Tired of not being able to align the flex sheet sideways?
Try this corner guide and get consistently alignment to the not just on the back but also sideways..
(Note: Using full length needs an ordinary M3 nut on the left side so I doesn't hit the motor)
How to:
1. Align to the back then slide all the way to the right.
2. Align to the right then slide all the way to the back.
3. Shove the flex bed corner to the guides corner (quickest but not the most accurate).
Try this corner guide and get consistently alignment to the not just on the back but also sideways..
(Note: Using full length needs an ordinary M3 nut on the left side so I doesn't hit the motor)
How to:
1. Align to the back then slide all the way to the right.
2. Align to the right then slide all the way to the back.
3. Shove the flex bed corner to the guides corner (quickest but not the most accurate).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
