Thingiverse
CR7 Keychain
door Dezno_dt
0
Downloads
3
Likes
1
Makes
Quality
Layer Height: 0.16 mm (balance between detail & speed)
Initial Layer Height: 0.2 mm (better adhesion)
Walls
Wall Line Count: 3
Wall Ordering: Inside to Outside
Top/Bottom
Top Layers: 5 (ensures full coverage, no gaps)
Bottom Layers: 4
Top Surface Skin: Enabled
Ironing: ✅ Enabled
Infill
Infill Density: 15% (enough for strength, doesn’t waste time/filament)
Infill Pattern: Grid
Speed
Print Speed: 50 mm/s
Wall Speed: 30 mm/s (cleaner walls)
Top/Bottom Speed: 25 mm/s (better surface)
Cooling
Fan Speed: 100% after layer 2
Initial Fan Speed: 0% (first 2 layers stick better)
Adhesion
Build Plate Adhesion Type: Skirt (no brim needed for flat keychain)
Layer Height: 0.16 mm (balance between detail & speed)
Initial Layer Height: 0.2 mm (better adhesion)
Walls
Wall Line Count: 3
Wall Ordering: Inside to Outside
Top/Bottom
Top Layers: 5 (ensures full coverage, no gaps)
Bottom Layers: 4
Top Surface Skin: Enabled
Ironing: ✅ Enabled
Infill
Infill Density: 15% (enough for strength, doesn’t waste time/filament)
Infill Pattern: Grid
Speed
Print Speed: 50 mm/s
Wall Speed: 30 mm/s (cleaner walls)
Top/Bottom Speed: 25 mm/s (better surface)
Cooling
Fan Speed: 100% after layer 2
Initial Fan Speed: 0% (first 2 layers stick better)
Adhesion
Build Plate Adhesion Type: Skirt (no brim needed for flat keychain)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
