CraftBot Top Enclosure

Update (2017/06/22):
CraftUnique recently released a PETG dome cover with an 80mm activated carbon filter for CraftBot Plus & CraftBot 2.

https://craftunique.com/item/craftbot2-petg-dome-cover


---------------------------------------------------------
Below is my custom top enclosure for my CraftBot prior to CraftUnique's new dome cover, see above.

I purchased the 5-sided acrylic clear cube from MisterPlexi, part number is: AC14-16, a 14"W x 14"D x 14"H cube with the bottom open.

http://www.misterplexi.com/products/ac14-16.html

Just print out the box holders, screw them to the top of your CraftBot, put the box on it, load your filament from under in the back and you're ready to print.

Note: I have heard from other CraftBot users reported that with fully enclosed (based on other enclosure designs), the temperature inside may rise too high which may affect your print results or extruder/hotend, especially in a hot summer day.

So my design probably would face ab