Craftsman 10 Inch Table Saw Insert

I needed to replace the insert on an older Craftsman table saw. This is specifically for Model No. 152.221040
It does not have the opening for the splitter.
It does have holes for the set screws and retaining bolt.
You will need to tap set screw holes. I believe I used a 1/4x28 tap.
Set the walls for the screw holes to 6-10 and they should be plenty strong enough.
The dovetails are VERY tight. I had to use a vise and blocks to press each together. I didn't use any glue.
I printed on a Bambu X1C in PETG and have not had any problems.
Dimensions: W - 95mm, D - 340mm, H - 14.9mm
without the set screws, it was about 1/2 mm too shallow for my saw.