Thingiverse
Craftsman Tool Hanger
von lsiunsuex
9
Downloads
3
Likes
0
Makes
A fitting to hang Craftsman 20v tools from a hook.
Used 50% infill to give it strength as some tools are heavier than others. Less infill might work too. Took all of 3 hours to print on Anycublic Mega X.
Good way to clean up tool clutter on a shelf.
Fitting doesn't lock into place but holds the drill just fine. Easy to remove and put back on for quick grabs.
Used 50% infill to give it strength as some tools are heavier than others. Less infill might work too. Took all of 3 hours to print on Anycublic Mega X.
Good way to clean up tool clutter on a shelf.
Fitting doesn't lock into place but holds the drill just fine. Easy to remove and put back on for quick grabs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
