Thingiverse
Craftsmen31ccWeedwackerBumper
von BruceBach
0
Downloads
2
Likes
1
Makes
Printed EvilTeach's bumper out and went to install it and found the craftsman model I have uses a square head bolt not a hex head bolt. So made this one.
The square hole is 12.46mm and fits the bolt on mine nice and snug. This bolt is pretty old though so if you need/use this you may want to experiment a bit before printing the whole thing.
The square hole is 12.46mm and fits the bolt on mine nice and snug. This bolt is pretty old though so if you need/use this you may want to experiment a bit before printing the whole thing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!