Crane Fly

NB! These brushless motors get crazy hot, not ideal for printed plastic! Would love to see the motor mounts done up in heat resistant material but as a std 3D print things are going to warp if you crash once the motors are cooking.

I've created custom inner voids so you can print at 100% fill.

To assemble, layout all the rods and parts and slowly work everything inwards.

Spot of hot glue to mount the camera and secure rods. Use hot air to clean up and smooth out and remove excess glue. I initially experimented with inserting a heated pin on each side to fix the camera, hence the two small holes.

Parts List:
Eachine-Tiny-QX90-Micro-FPV-Racing-Quadcopter-Spare-Parts-8_5x20mm-Coreless-Motor.
Micro 32bits F3 Brushed Flight Control Board Based On SP RACING F3 EVO Brush For QX95 QX90 QX80
Walkera QR Ladybird Blades Propellers for Eachine QX95 QX90
DasMikro Ultra Miniature PPM Signal Output 8CH Receiver
2mm Diameter Carbon rods (40.5mm x 4 / 58mm x4)
FX FX798T 5.8G 600TVL 2