Crash Bandicoot

InstructionsPrint with layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou can scale the X and Y axis but DO NOT scale the Z axis of any hueforge Filaments UsedPLA+ Sunlu BlackPLA BambuLab BrownPLA BambuLab Basic OrangePLA BambuLab YellowPLA BambuLab Ivory White Swap Instructionsstart with Blackat .96mm switch to Brownat 1.36mm switch to Orangeat 1.84mm switch to Yellowat 2.00mm switch to Ivory White for the rest All photos are of an actual print of my hueforge design. Use the same filament and colors and you can expect the same results. Make sure your print plate is clean for good adhesion. I like to put brims on my hueforges to make sure they don't lift or warp. If you have any issues with the print, feel free to shoot me a message. If you like this print, give me a boost!