Thingiverse
Creality CR-10 Mini IR Sensor Mount
door jneilliii
93
Downloads
35
Likes
0
Makes
Simple mount for the mini ir z probe sensor board found [here](https://miscsolutions.wordpress.com/mini-height-sensor-board/) to be used with Auto Bed Leveling. Requires flashing the firmware.
Uses stock screw hole on left side after removing the fan housing and allows for height adjustment to get to just the right spot.
Connect VCC to 5V, GND to Z end stop ground pin and OUT to the other Z end stop pin. Enable FIX_MOUNTED_PROBE in marlin and then determine and set the Z Probe offsets.
Uses stock screw hole on left side after removing the fan housing and allows for height adjustment to get to just the right spot.
Connect VCC to 5V, GND to Z end stop ground pin and OUT to the other Z end stop pin. Enable FIX_MOUNTED_PROBE in marlin and then determine and set the Z Probe offsets.
jneilliii publiceert ook op
59 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
