Creality CR-6 SE Cable Support

2020-12-13, added a version 2 with support for the bowden tube. I guess could be called a remix of the remix? thing:4657122

Warning, you may need to drill, ream, file... the hole for the bowden tube to get a nice slide fit. Don't make the hole too big where the tube just falls through. There has to be a little bit of resistance to negate the force of the flexing bowden tube above it.

As always, supports on. And if tabs break after the print, layer adhesion is incorrect, adjust temperature settings.


2020-12-09, Notes from some of the comments received:

If tabs end up breaking you may want to increase temperature and adjust setting for better layer adhesion. This part was originally printed with the Creality sample PLA and came out very solid.

Dimensions of the stepper motor cover are 46.4mm x 51.4mm x 36mm height. Walls are 2mm thick. You can use these numbers to check your printer accuracy.

The Creality CR-6 SE print head cable installation is a bad design. The con