Creality CR10S Pro USB Support

This is a small braket to support the mini USB connector when plugged into the side of the CR10S Pro printer (and maybe others).

The mini USB connectors are not very stable with the weight of the cable dragging it down and it puts a lot of strain on both the plug and also the socket on the main board inside the printer. As you can see from the picture my USB plug had become bent due to the cable pulling down on it.

Therefore I designed this small bracket in TinkerCad that is simply stuck onto the side of the printer to provide support for the plug and stop it drooping and also give a more stable connection.

Once printed, just stick some double sided tape on the back and cut out the hole. Then put the USB plug through the hole and plug the USB plug into the printer. Then just slide the bracket over the plug and stick to the side of the printer.

This does not interfere with the MicroSD card slot.