Creality Ender 3 Display Electronics Cover

Creality Ender 3 Display Electronics Cover made in Fusion 360.
There are other covers in Thingiverse available but I wanted to make my own cover because I like to model.

- No Support needed
- Factory screws can be reused
- Glue advised for better adhesion

I have used Cura for slicing.
I needed glue for a good adhesion for the thin lines that mark the holes in the first layer.
Also made some settings adjustments in Cura for the initial layer after watching `the perfect first layer videos´ on YouTube. I am a beginner in 3D printing so still learning :o)
The end result was very good. Fits perfectly.