Creality Ender 3 Pi camera mount

You can choose between a version for LED stripes (50x9mm it should fit most stripes) and a version without.
I had the best video with cold white LED's otherwise the Pi cam starts to noise a lot.

##Assembly instructions
You need the following screws:
M2x12 or M2x16 & nut to screw the camera part to the arm
M2x8 or M2x12 & nut to screw the arm to the base
M2x12 to tighten the base to the ender 3
All screw holes are 2mm wide so a M2 screw would be enough and you don't need a nut

I have fixated the camera cable to the other stepper, extruder & hotend cables. 100cm cable lenght is very tight if you have the raspberry pi on the back right corner of the ender 3 but it will fit.