Thingiverse
Creality Ender 5 Raspberry Pi Camera Mount
door justjohn
101
Downloads
39
Likes
1
Makes
A mounting I made for a Rasberry Pi 3 and camera v1.3 for my Ender 5.
I'm using this with Octoprint for remote monitoring.
It doesn't need any other hardware, just print and use it.
There is a ball joint to adjust the camera angle.
The screw down nut took a bit of screwing and unscrewing to get it working well, I added a bit of washing up liquid to help.
The clips that hold the camera on work well for cable clips too.
You will need at least a 30cm ribbon cable for the camera.
For the Pi clips, install them on the printer first and then clip the Pi in.
No supports required. I printed with a brim.
I'm using this with Octoprint for remote monitoring.
It doesn't need any other hardware, just print and use it.
There is a ball joint to adjust the camera angle.
The screw down nut took a bit of screwing and unscrewing to get it working well, I added a bit of washing up liquid to help.
The clips that hold the camera on work well for cable clips too.
You will need at least a 30cm ribbon cable for the camera.
For the Pi clips, install them on the printer first and then clip the Pi in.
No supports required. I printed with a brim.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
