Creality K1 Side load spool holder

Hello everyone.This is my take on mounting both the spool holder and filament sensor on the side of the Creality K1. This modle is made to fit in the printer's bed size at 45 degrees.To assemble the sensor and PFTE fitting on the bracket the stock screws can be used. Do not tighten them too mutch.To assemble the bracket onto the printer, remove the 3 screws on the back and use longer ones. between 14 and 16 mm M3 screws.Use the stock roll mounted on this bracket.A pigtail is needed to extend the sensor cable by 6 or 7 cm. You can also splice it together ;)Enjoy ;)