Thingiverse
Creality Mod- Z Endstop Offset
door AdditiveTech
55
Downloads
38
Likes
0
Makes
Mod that allows you to move the Z-stop limit switch (aka endstop) on your Creality printer.
Printer Compatibility:
CR-10s
CR-10 V3
Ender 3
Let me know if it does or does not work for more printers.
Installation:
1. Unplug Z endstop
2. Remove the entire T shaped support bracket by loosening (but not completely removing) the 4 hex bolts.
3. With the bracket off the printer, now completely unscrew these four bolts
4. Unbolt the Z endstop circuit board from the old plastic plate by unscrewing two hex bolts.
5. Install the Z endstop to the new 3d printed piece. If the bolt holes are too small, drill them out with a 2.5 mm drill or reprint with larger holes by using the "horizontal expansion" setting in cura
6. Reinstall everything in the reverse order as disassembly.
Printer Compatibility:
CR-10s
CR-10 V3
Ender 3
Let me know if it does or does not work for more printers.
Installation:
1. Unplug Z endstop
2. Remove the entire T shaped support bracket by loosening (but not completely removing) the 4 hex bolts.
3. With the bracket off the printer, now completely unscrew these four bolts
4. Unbolt the Z endstop circuit board from the old plastic plate by unscrewing two hex bolts.
5. Install the Z endstop to the new 3d printed piece. If the bolt holes are too small, drill them out with a 2.5 mm drill or reprint with larger holes by using the "horizontal expansion" setting in cura
6. Reinstall everything in the reverse order as disassembly.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
