Thingiverse
Creality Runout Sensor Bracket for Ender 3 V2
von Jamie258
3
Downloads
1
Likes
0
Makes
Created this from scratch based on Blazefang01's design. Original did not line up with the feeder very well on my Ender 3 V2. Should fit the Ender 3 as well, but not tested.
Created in TinkerCad so pretty basic design.
Slides in place tightly on top of stepper motor. No additional tools or screws required.
Created in TinkerCad so pretty basic design.
Slides in place tightly on top of stepper motor. No additional tools or screws required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!