Creality Space Pi Drying Stand!

I got the Creality Space Pi to dry filament because I heard good things about it. However, I noticed that while filament is drying, the base of the dryer gets pretty hot, and I wanted a way to raise it for cooling and to prevent any potential heat damage. So, I created this stand, and it fits it perfectly! The stand in the picture is printed fully in PLA (mix of Polymaker and Bambu), and it has been tested with 12 hours of drying at 50 degrees C and observed no deformation on the stand (the base doesn't get as hot as the inside, but I wanted to be sure).DISCLAIMERThis stand made of PLA hasn't been tested at the highest drying setting of 65-70 degrees C, so take caution if you decide to print using PLA and dry filaments at a higher temp. I don't think anything bad will happen since the base doesn't get as hot and has vent holes to cool. If you have multiple colors of PETG or ABS, those materials would be the safer option, but the colors I have for those materials are lim