Thingiverse
Creality Spool Holder v2 with locking ring
por globalns
37
Descargas
27
Likes
1
Makes
Drop in, 100% compatible, replacement for second generation Creality spool holder and locking ring.
90mm for the standard size, 50mm for a narrower spool.
No shoulder on one side to allow a smaller opening spool to be used. Locking ring on both ends.
I tried to thin out the the central shaft to from 5mm to 3mm in the v4, but couldn't figure out how to export it, I'm leaving it for now.
The locking ring pins are slightly off-center, so it's a very tight lock in one direction and looser in the other.
90mm for the standard size, 50mm for a narrower spool.
No shoulder on one side to allow a smaller opening spool to be used. Locking ring on both ends.
I tried to thin out the the central shaft to from 5mm to 3mm in the v4, but couldn't figure out how to export it, I'm leaving it for now.
The locking ring pins are slightly off-center, so it's a very tight lock in one direction and looser in the other.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
