Creality UW-01 Elegoo Plate Adapter

This is an Adapter for the UW-01 plate mount to work with an Elegoo plate.This also has a block to keep the nut from spinning on the knob. Made this out of PLA with my Ender 5 so it would have no issues with IPA in the cure station. Made for a 5mm pan head hex screw to be used and a 5mm plastic nutsert in the main body.

Use a hot iron to insert a nutsert into the main body. Make sure screw head is completely recessed into the lower body and the nutsert is completely recessed and flush into the upper body. When this is finished, the nutsert and screw should clamp down on the creality platform through it's 6mm hole. This will hold in place well enough to use the stock elegoo platform clamp on it. THe square block for the handle just has a hex made into it so all you do there is turn the nut around and slide it in. This will keep the nut from wanting to spin on you when your sliding the platform up and down.