Creation Crate Arduino Mount

My stepson enjoys Creation Crate kits. Each comes with a breadboard and a new Arduino.

The problem is the projects are built with breadboarding wires and are very fragile when finished. It's a great excuse for him to do the project again, but it's more like a chore to keep them running.

This widget allows the breadboard and the Arduino to be attached to each other. By keeping the two modules in the same position to each other, the wires are far less likely to come loose.

This design depends on screws to attach the Arduino to the widget. This reduces the amount of PLA required to a very small amount. I could also design one that uses a lot more plastic and acts more like a tray.

The screws are https://www.amazon.com/Hxchen-Screws-Replacement-Black-Laptop/dp/B07V9SDWK3?keywords=hard+drive+caddy+screws&qid=1675047920&s=industrial&sr=1-1-spons&psc=1&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUExUVVCVVZOUlpKUFY1JmVuY3J5cHRlZElkPUEwNDA5OTYwM0lCQ0FIUVA5NzY1WCZlbmNyeXB0ZWRBZElkPUExMDQ2MTYzM1RXN